[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Working with Plexiglas



Original poster: "Luc by way of Terry Fritz <twftesla-at-qwest-dot-net>" <ludev-at-videotron.ca>

Hi Greg

If I want a strait cut I use a really sharp carbite blade with
many tooth and I push the plexi fast. I never try it but if you
want a curve cut you need a jigsaw but try the old machinist
trick just 2 tooth is need on the thickness of the material when
you cut; for 1/4", 8 tooth by inch on your blade, sharp tooth,
this way you will go fast and the plexi do not have the time to
melt. If you have to much problem try liquid coolant ( put a
track of pure water on the line you cut or maybe soapy water ) a
little sanding that's it. I saw before a guy use a propane torch
to finish the edge like a mirror, I try it but don't have a good
result It's probably take a lot of practice.

Hop I could help,
Cheers,

Luc Benard      

Tesla list wrote:
> 
> Original poster: "Gregory Hunter by way of Terry Fritz
<twftesla-at-qwest-dot-net>" <ghunter31014-at-yahoo-dot-com>
> 
> Dear List,
> 
> I sometimes use Plexiglas for Tesla coil components,
> but I still haven't figured out how to work the stuff.
>  When I saw it with an electric jigsaw, the cut tends
> to fuse back together after the blade has passed.
> When I finally do get the stuff cut, I have a rough
> edge that defies my best efforts to smooth & polish
> it.  What's the secret to cutting Plexiglas sheet?
> How do I get a professional-looking finish on the
> edges?  What's the best glue to use with it?  How do I
> use power tools on it without melting it?
> 
> If the explanations get really long, or get into
> subjects not of general interest to TC builders,
> kindly reply off-list.
> 
> Regards,
> 
> Greg
> http://hot-streamer-dot-com/greg
> 
> __________________________________________________
> Do You Yahoo!?
> Get personalized email addresses from Yahoo! Mail
> http://personal.mail.yahoo-dot-com/