[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Perfboard for MMC



Original poster: "brian by way of Terry Fritz <twftesla-at-qwest-dot-net>" <ka1bbg1-at-mcttelecom-dot-com>

Hi, well maybe your looking for Vector Board, they started the perf board
stuff going with pins to be pounded into the vector board then components
soldered on top and wire wrap below on the pins. cul brian

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Sunday, May 20, 2001 8:51 PM
Subject: Re: Perfboard for MMC


> Original poster: "Area31 Research Facility by way of Terry Fritz
<twftesla-at-qwest-dot-net>" <rwstephens-at-hurontario-dot-net>
>
> Vero, Varo (sp?) board. Low IQ day here 2.
>
> >
> > ----- Original Message -----
> > From: <mailto:tesla-at-pupman-dot-com>Tesla list
> > To: <mailto:tesla-at-pupman-dot-com>tesla-at-pupman-dot-com
> > Sent: Sunday, May 20, 2001 19:38
> > Subject: Perfboard for MMC
> >
> > Original poster: "William R. Langston by way of Terry Fritz
> > <<mailto:twftesla-at-qwest-dot-net>twftesla-at-qwest-dot-net>"
> > <<mailto:blangsto-at-iwvisp-dot-com>blangsto-at-iwvisp-dot-com>
> >
> > Hello all,
> >
> > Can anyone point me to an inexpensive site for getting perfboard to
> > construct a fairly large MMC? Stupid as it may seem, I am even having
> > trouble recalling a usable trade name for perforated insulating,
> > connection board so I can look it up in McMaster or Allied.
> >
> > This is not a high IQ day out here in the desert ;-o
> >
> > Thanks,
> > Bill L.
> >
> >
>
>
>
>
>