[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Drying tranny oil



Original poster: "Jim Lux by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jimlux-at-earthlink-dot-net>

Filtering and drying are entirely possible...  You can look on the web for
firms that sell gear to do this, and then get ideas on how to build your own
treatment rig.

Drying: heat, vacuum, dessicant....  Oil can be heated to hotter than
100C.... Pull a vacuum and it "slowly" degasses, gentle agitation in a
vacuum might help, at least to bring new oil to the surface.  Silica gel
(e.g.) or metallic sodium can be used to adsorb or react out the water.

Filtering is a bit trickier, because you need to filter out really, really
tiny particles... A regular old automotive type filter isn't going to hack
it, but if you can find some very high performance filters, you're all set.
(of course, the filters might cost more than brand new oil...)

Or, rig yourself up a little oil test set (NST, microammeter, test cell,
variac) and see what the breakdown voltage of your oil is.  It might be more
than "good enough"

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Wednesday, April 03, 2002 10:17 PM
Subject: Drying tranny oil


> Original poster: "Ben McMillen by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<spoonman534-at-yahoo-dot-com>
>
>
> Hi all,
>   I recently acquired 110 gallons of transformer oil.. Unfortunately, when
> I got it I had to put it into a 55 gal drum that had some water in it
> (Bad.. I know.. but it was drain it or loose the free oil) Is there any
way
> to dry the oil (get the water out)? I was wondering if you could maybe put
> the drum under a vacuum.. Also, the oil had alot of crud (corrosion from
> the tanks it was in).. can this be easily filtered out? I don't want to
use
> the oil and then have problems with conductive stuff floating around
> inside.. ;)
>
> Coiling In Pittsburgh
> Ben McMillen
>
>
>