[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: vacume gap spacing



Original poster: "Rodney Goolsby by way of Terry Fritz <teslalist-at-qwest-dot-net>" <jeronimo-at-bright-dot-net>

Sorry, I was in a hurry last post so I didn't take the time to describe my
gap.  It isn't an actual vacuum, as in no air present in the gap, but rather
2 .5" copper pipes running into 2 pvc elbows hooked to a T-joint with a 3/8"
gap in between the copper pipes.  I'll be using a 2 amp hand vac. I found
laying in the basement to suck air through the pipes, hopefully quenching
the spark.  Not like I'm trying to steal his design but this gap is similar
to the "Sucker Gap" found on Steve's High Voltage Website. (
http://hot-streamer-dot-com/srward16/images/BIGGAP02_jpg.jpg )

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, July 31, 2003 8:48 PM
Subject: Re: vacume gap spacing


 > Original poster: "Dr. Resonance by way of Terry Fritz
<teslalist-at-qwest-dot-net>" <resonance-at-jvlnet-dot-com>
 >
 >
 > It will all depend on the exact level of vacuum you are running, ie, how
 > many microns.
 >
 > Dr. Resonance
 >
 > Resonance Research Corporation
 > E11870 Shadylane Rd.
 > Baraboo   WI   53913
 > ----- Original Message -----
 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > To: <tesla-at-pupman-dot-com>
 > Sent: Thursday, July 31, 2003 12:20 PM
 > Subject: vacume gap spacing
 >
 >
 >  > Original poster: "Rodney Goolsby by way of Terry Fritz
 > <teslalist-at-qwest-dot-net>" <jeronimo-at-bright-dot-net>
 >  >
 >  > How wide should I set the gap on the small vacume gap I designed?  I'll
be
 >  > using a 12/60 nst bank and a .015uf capacitor.
 >  > thanks in advance
 >  >
 >  >
 >
 >
 >