RE: HV Wire - electrical tape?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Mccauley, Daniel H by way of Terry Fritz <teslalist-at-qwest-dot-net>" <daniel.h.mccauley-at-lmco-dot-com>

Our HiPot tester at work, that tops out at 75kv uses RG-8 for the high
voltage lead.


Just remember that your HiPot tester is relatively low current.

Dan




Perhaps this could be used here.  The braided shield is hooked to gound.

--jeff
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, January 02, 2003 12:17 PM
Subject: Re: HV Wire - electrical tape?


  > Original poster: "Dr.Resonance by way of Terry Fritz
<teslalist-at-qwest-dot-net>" <resonance-at-jvlnet-dot-com>
  >
  >
  > It's a waste of time and ends in a cobble job that may or may not work
  > properly.
  >
  > Just use standard neon GTO wire for hooking up all NST powered coils.  It
  > works great and is flexable.

<SNIP>