[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Spun Aluminum Toroid Bulk Buy?



Original poster: "Mccauley, Daniel H by way of Terry Fritz <teslalist-at-qwest-dot-net>" <daniel.h.mccauley-at-lmco-dot-com>


I didn't know Dr. Resonance supplied toroids?  What size toroids does he
usually purchase / sell??

Dan



 > Hi All,
 >
 > Would it be easier to run through Dr. Resonance?  I'm
 > ordering a 34x8 from
 > him on his next order.  We could lower the price further if
 > we got more
 > pieces.  I just talked to him and he will be ordering soon.
 >
 > David E Weiss
 >
 >  > Original poster: "Dave Kyle by way of Terry Fritz
 > <teslalist-at-qwest-dot-net>"
 > <dave-at-kyleusa-dot-com>
 >  >
 >  >
 >  > It has been a at least two years since anyone on the list
 > has done a spun
 >  > aluminum toroid bulk buy and I was wondering if there was
 > enough pent up
 >  > demand to make another one worth while. Come on all you
 > folks with High
 >  > Voltage Disease (HVD) you KNOW you NEED one. J
 >  >
 >  >
 >  >
 >  > I have a beautiful 6 x 24 inch spun aluminum toroid from
 > an earlier bulk
 >  > buy and lately have been thinking a 9 x 30 inch would be
 > especially nice
 >  > for my larger coil. I can then migrate the 24 inch to my
 > new DC coil which
 >  > is currently under construction. IMHO nothing beats a spun
 > toroid for
 > spark
 >  > performance and appearance. Fact is they look cool even
 > with the power
 > off.
 >  >
 >  >
 >  >
 >  > I have no experience with organizing a buy but if enough
 > people express
 >  > interest and hopefully some of the previous organizers
 > offer their advice
 > I
 >  > would be happy to do so. My only interest is getting a big
 > toroid for
 >  > something less than the grotesquely high single unit
 > price. I have no
 >  > intention of charging any service fee and will pay what
 > everyone else pays
 >  > if we can get the bulk buy.
 >  >
 >  >
 >  >
 >  > A previous buy for 9 x 30 spun aluminum toroids had these results:
 >  >
 >  >
 >  >
 >  > What vendor do we typically use? O.W. Landgren
 >  >
 >  >
 >  >
 >  > What is the minimum buy to get to a reasonable cost? ~15
 >  >
 >  >
 >  >
 >  > What is that cost? ~$310 a piece
 >  >
 >  >
 >  >
 >  > We need just 14 more people to make this a reality. Reply
 > to the list or
 > if
 >  > your prefer contact me directly.
 >  >
 >  >
 >  >
 >  > Dave
 >  >
 >  > =========================================
 >  > Dave Kyle
 >  > Austin, TX USA
 >  > Email: dave-at-kyleusa-dot-com
 >  >
 >  >
 >  >
 >  >
 >  >
 >
 >