[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Knife switch

To: tesla-at-pupman-dot-com
Subject: Re: Knife switch
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 10 Feb 2004 06:00:39 -0700
Resent-Date: Tue, 10 Feb 2004 06:06:32 -0700
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <L0jOmC.A.aJD.RdNKAB-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: Matthew Smith <matt-at-kbc-dot-net.au> 

Tesla list wrote:
>Original poster: "Luke" <Bluu-at-cox-dot-net>
>Can any one tell me where I can buy some Knife Switches?

Sorry can't answer your question but will comment:  if you plan to use them 
to make a good looking control panel for your coil, for safety, I would 
recommend using a low voltage (< 50V) control circuit rather than running 
mains through them.

Cheers

M

-- 
Matthew Smith
Kadina Business Consultancy
South Australia
http://www.kbc-dot-net.au

Prev by Date: Re: Chokes vs Safety Gaps
Next by Date: Re: Knife switch
Prev by thread: Re: Knife switch
Next by thread: Re: Knife switch
Index(es):
- Date
- Thread