[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Terry Gap vs. TCBOR...



Original poster: Terry Fritz <teslalist-at-twfpowerelectronics-dot-com>

Hi Brett,

This will be very interesting!!  I have long thought that the multigaps 
tends to burn off less power so the coils are more efficient.  They also 
quench better.  Looking forward to what your experiments find!

Cheers,

         Terry


At 07:54 PM 2/27/2004, you wrote:
>Luke (and Terry might be interested too),
>
>I have started the restoration of the Fritz linear
>static gap.  I mixed up some T-88 aircraft grade epoxy
>(good stuff I might add) and set up the cu pipes on a
>nice 1/2" thick Lexan base I pilferred from my
>plastics crate.  Tomorrow it should be pretty well
>cured and I can start firing up and performing tests.
>
>
>I'll soon be providing pictures of both the gaps as
>well as scope waveforms of quenching for the
>respective units.
>
>Just remember, the diameter of the pipes is much
>greater in the TCBOR gap, so heat sinking/cooling will
>be naturally better in the TCBOR.  This is definately
>something to consider when analysing the results.
>This test will definately not be controlled, nor will
>it be double blind.  Nevertheless, I think some
>tentative conclusions may not be life threatening.
>
>I must also not forget to take measurements of each
>gap and provide total gap spacing for each gap unit
>tested.  I used two index cards stacked to space the
>pipes in the Fritz gap.  Those will be easy to measure
>with a caliper.  I can use a feeler gauge for the
>TCBOR.....something I should have done a long time
>ago.
>
>I hope a few people will take an interest in this
>little project.  I know Luke is interested (plus me),
>so that makes it worth doing right there.  What we're
>really wanting to know here is whether or not
>distributing a spark over many gaps for greater
>quenching is desirable over using few gaps to minimize
>loss?  Where is the balance?  Is this a sensitive
>parameter that must be matched to specific systems?
>If we're lucky we might learn more about whether or
>not 1st notch quenching is the "holy grail" of spark
>gap design (see Richee Burnett's page).
>
>-Brett