[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

"These might interest MMC builders.." STK polypropylene capacitors



Original poster: "Scott Hanson" <huil888-at-surfside-dot-net> 

John -

At first glance, polypropylene capacitors for "$0.50 to $1.00 each" sounds
interesting, but once you get into the details of the specifications things
don't look quite so good.

First, STK does not offer a direct equivalent for the Cornell-Dubilier 942
series, which have become the defacto "standard" for MMC use.

It looks like the best STK candidate would be the MP89 "high peak current"
series, but these are of double-metallized film construction, not the
metallized film/foil hybrid construction of the CDE 942 series. Compared to
film/foil, the weakness of the double-metallized construction is at the end
terminations of the roll, where the leads attach. These tend to fail (burn
away) in high peak current applications like a Tesla coil MMC.

Comparing the specs shows how much more robust the CDE film/foil
construction is.

The peak and RMS current ratings are as follows for a .015uF, 2,000VDC
capacitor:

STK MP89, peak current 144A, RMS current 8.9A
CDE 942,    peak current 432A, RMS current 13.5A

So, for a .15uF, 2kV capacitor the CDE 942 can handle THREE TIMES the peak
current of the STK capacitor. The cost differential is less than 3X, so the
STK parts really are not cost effective compared to the CDE's.

Regards,
Scott Hanson


---
[This E-mail scanned for viruses by Surfside Internet]