[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: SSTC Boards Now Taking Orders (BONUS)



Original poster: "Daniel Kline" <daniel_kline-at-med.unc.edu> 

Heyas :)
I'll take a board, even if I didn't get in under the wire for the free
stuff. But if I did, great!
Thanks,
Dan
(Let me know where to send what :)

 > -----Original Message-----
 > From: Tesla list [mailto:tesla-at-pupman-dot-com]
 > Sent: Thursday, March 25, 2004 10:57 PM
 > To: tesla-at-pupman-dot-com
 > Subject: Re: SSTC Boards Now Taking Orders (BONUS)
 >
 >
 > Original poster: "Jim Mitchell" <electrontube-at-sbcglobal-dot-net>
 >
 > I will build the first 5 people to order a board, a full
 > bridge of IGBT
 > transistors capable of handling voltages up to 240v and I get
 > 20" sparks at
 > 120v using this system.  Remember, this is a Self Resonant
 > system,  NO
 > TUNING INVOLVED.  That way, you can swap out the secondary
 > coil for any
 > secondary coil (provided it has a low enough resonant
 > frequency)  and use
 > that coil in this circuit.  I will include some of the hard
 > to find parts
 > for the first 10 buyers.
 >
 > Regards - Jim Mitchell
 > ----- Original Message -----
 > From: <mailto:electrontube-at-sbcglobal-dot-net>Jim Mitchell
 > To: <mailto:tesla-at-pupman-dot-com>Tesla list
 > Sent: Thursday, March 25, 2004 6:54 PM
 > Subject: SSTC Boards Now Taking Orders
 >
 > Hello List:
 >
 > I will be selling SSTC driver boards soon.  Professionally
 > made at a PCB
 > house,  solder mask, silk screen, the works.
 >
 > The board is configured for a Self Resonant Feedback system
 > based on Aron
 > And Justin's design at <http://www.hvguy-dot-com>www.hvguy-dot-com
 > The board is
 > the driver only,  the control logic and the gate drive ICs.
 > All you need
 > to provide is an H bridge or Half Bridge and a few parts that can be
 > sampled from Maxim and TI-dot-com for free.  The board will use
 > UCC37322/1 9A
 > gate drivers which will allow a very wide range of MOSFETs
 > and IGBTs that
 > the board can drive.
 >
 > If anyone is interested,  price per board is 27$ each,  I am
 > only having 10
 > made in the first batch so if anyone is interested,  reply to
 > this email at
 > <mailto:Electrontube-at-sbcglobal-dot-net>Electrontube-at-sbcglobal-dot-net
 >
 > Regards - Jim Mitchell
 >
 >
 >
 >