[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Advice on Primary
- To: tesla@xxxxxxxxxx
- Subject: RE: Advice on Primary
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Wed, 23 Feb 2005 08:06:50 -0700
- Delivered-to: firstname.lastname@example.org
- Delivered-to: email@example.com
- Old-return-path: <firstname.lastname@example.org>
- Resent-date: Wed, 23 Feb 2005 08:08:12 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <jwN8tB.A.EIG.RxJHCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Ralph Zekelman" <gridleak@xxxxxxxxxxxxxx>
Original poster: Jim Lux <jimlux@xxxxxxxxxxxxx>
Properly formed notches won't have a problem, but if you want holes, why
not split your supports down the middle (bisecting all the holes).
wind up with two basically identical combs. You'd attach the lower half
the baseboard, lay the tubing into the half holes, then carefully put
top half down over it, and tighten the screws (use nylon screws)
I have used this method for making spacers for the Archimedes and the
solenoid coils for the bipolar. It works very well with rectangular
that machines easily. It drills and taps cleanly for nylon screws.
McMaster-Carr is a good source for the Delrin.