[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Resulting static after TC runs
- To: tesla@xxxxxxxxxx
- Subject: RE: Resulting static after TC runs
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Mon, 28 Feb 2005 12:54:54 -0700
- Delivered-to: firstname.lastname@example.org
- Delivered-to: email@example.com
- Old-return-path: <firstname.lastname@example.org>
- Resent-date: Mon, 28 Feb 2005 12:55:05 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <dPsoPC.A.zYH.Yc3ICB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Derek Woodroffe" <tesla@xxxxxxxxxxxxxxx>
I have noticed a similar static charge on a couple of static gap
coils, and my smaller OLTC.
I put it down to the last voltage swing, either -ve or -ve from the
secondary would leave a charge on any non conducting surface..
With the amount of control you have over your burst length you are
probably leaving a net +ve or -ve charge after each burst especially if you
are cutting off the burst at a half cycle. Maybe this net difference is what
is making the build up of charge..