[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Heat & Rotary Gaps



Original poster: FIFTYGUY@xxxxxxx

In a message dated 10/21/05 8:41:40 PM Eastern Daylight Time, tesla@xxxxxxxxxx writes:


> Just set up one of my twin coils with a propeller gap... > I found that after 10 seconds at 50% power, the > rotating tungsten rod was far to hot to touch!

What size tungsten rod are you using?
What is the gap distance between the stationary electrodes and the rotating one?
Are you using any additional gaps at the same time?


-Phil LaBudde