Re: twin stacked primary supports

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Mike Tucknott" <michael.tucknott@xxxxxxxxxx>

Hi Bart

Sound like a good idea if I get arcing between the layers, I did increase
the layer to layer spacing to 25mm between conductor surfaces.
If I get any problems I`ll report back with my findings

Cheers Mike T


> Original poster: "Barton B. Anderson" <bartb@xxxxxxxxxxxxxxxx>
>
> Hi Mike,
>
> As Gary mentioned, you'll need to insulate the two primary's. Given
> your supports are already drilled and cut, maybe you could add a
> channel on each side of the supports between the two layers so that
> acrylic (or some insulator) plate could be cut to size and slid into
> place in the channels (and glued).
>
> Take care,
> Bart
>