[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: top load height



Original poster: "huil888" <huil888@xxxxxxxxxxxx>

Joe -

This is a large coil - what will you be using for a HV power source? What is the input power rating, in KVA?

Regards,
Scott Hanson
----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Monday, April 02, 2007 9:45 PM
Subject: Re: top load height


Original poster: "Joe Smith" <proffessor@xxxxxxxxxxx>

Concerning my 16" diameter by 86" fiberglass secondary,,wound 80.5
inches w/#14solid,to one inch from the top,,with 6' diameter copper
covered sphere...
 ie: the topload should probably just clear the top of the secondary???
     or possibly sit on top??
Thanks
Joe.


On Sun, 01 Apr 2007 22:30:22 -0600, "Tesla list" <tesla@xxxxxxxxxx>
said:
> Original poster: "resonance" <resonance@xxxxxxxxxxxx>
>
>
>
> The base would be the lowest part of the toroid.  The center is
> referred to in Bart's JAVATC program as the "centerline" of the torus.
>
> Dr. Resonance
>
> >Dr., when you say "base of the toroid," do you mean the lowest part
> >of the toroid (which would be the underside of the cord) or the disc
> >in the center of the toroid?   Dennis
>
>
>
>
>
--
  Joe Smith
  proffessor@xxxxxxxxxxx

--
http://www.fastmail.fm - The way an email service should be