[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [] conical secondary (fwd)

To: tesla@xxxxxxxxxx
Subject: RE: [] conical secondary (fwd)
From: "Tesla list" <tesla@xxxxxxxxxx>
Date: Sat, 16 Jun 2007 18:45:40 -0600 (MDT)
Delivered-to: testla@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxxxxxxxx
Old-return-path: <mod1@xxxxxxxxxx>
Resent-date: Sat, 16 Jun 2007 18:45:40 -0600 (MDT)
Resent-from: tesla@xxxxxxxxxx
Resent-message-id: <1sCx6WXV8oD.A.ClE.0QIdGB@chip1>
Resent-sender: tesla-request@xxxxxxxxxx

---------- Forwarded message ----------
Date: Sat, 16 Jun 2007 19:14:34 -0500
From: David Thomson <dwt@xxxxxxxxxxxx>
To: 'Tesla list' <tesla@xxxxxxxxxx>
Subject: RE: [] conical secondary (fwd)

Hi Bart,

> and flat secondary's are a real pain in a$$. Winding it is 
> easy, but building the supports for large flat coils is the 
> difficult part.

A large sheet of quarter inch Plexiglas works fine.  I have over a dozen
tight wound flat spirals up to 4 feet in diameter with various gages of
magnet wire on this type of form.

Dave

Prev by Date: Re: [] conical secondary (fwd)
Next by Date: Re: 15kVA 12.6kV pole pig (fwd)
Previous by thread: Re: [] conical secondary (fwd)
Next by thread: Re: [] conical secondary (fwd)
Index(es):
- Date
- Thread