[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Let's try this again... - was: [TCML] MMC pics



Nicholas J. Goble wrote:
Today I made a new MMC. I took apart the old one and straightened all the leads the best I could. I then found an unused cutting board (it's blue, I hope that doesn't matter) in my kitchen and used it to mount the caps. I drilled holes in the board and cut it lengthwise to make two long, narrow boards (it's tough to cut the plastic with a jigsaw; it melts behind the blade). I used too much solder than I wanted to, the leads weren't clean.

I made two boards of six caps. The caps are in series with the resistors parallel. Pictures submitted for approval.

http://www.flickr.com/photos/28523883@N06/2662861930/in/photostream/
http://www.flickr.com/photos/28523883@N06/2662862400/

What do you think?  Are they Tesla worthy??
Now they look ok. I would prefer physically larger resistors, or several in series, but these probably will work. To cut plastic with a jigsaw, apply some oil to the blade. Cuts like butter then.

Antonio Carlos M. de Queiroz
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla