[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Disassebling a huge transformer



As I understand it you want inductance and not DC resistance, right?
Of course if the ribbon part was the secondary, you'd have to deal with
large amounts of current at low(er) voltage which would probably be more
difficult than, say, 120v at a lower current.

On Mon, 21 Jul 2008, garry neeley wrote:

> It is not a typical 2 winding transformer.  It has 1 winding with taps but
> its not wound with wire.  It's wound with thick copper ribbon about 4-6
> inches wide.  It's a huge current type transformer.  It just wouldn't cut it
> as is.  Almost no dc resistance.
> 
> On Mon, Jul 21, 2008 at 10:19 AM, Chip Atkinson <chip@xxxxxxxxxx> wrote:
> 
> > Hi Garry.
> >
> > I'm puzzled why you'd want to go through the trouble of disassembling the
> > transformer.  What about just putting a resistor across the secondary of
> > the ballast transformer and running the current through the primary? When
> > you want a small amount of inductive ballasting use a smaller resistor.
> >
> > You could construct a resistor bank and put taps in it so that you could
> > easily adjust the resistance and therefore ballasting.
> >
> > Chip
> >
> > On Mon, 21 Jul 2008, garry neeley wrote:
> >
> > > Het Guys I aquired a gigantic transformer for my pig ballast.  I want to
> > > rewind it to make a reactor.  My question is Does anyone know of a good
> > way
> > > to get the I seperated from the E.  The I section is bolted together with
> > > threaded rod.  At the top where the E and I meet the laminations are
> > > interleaved together.  This transformer is big, mid section exceeds 25
> > > square inches.  Weighs over 300 lbs.  Should I simply cut the I section
> > > off?  Are there any good methods for this?
> > > Bamacoiler
> > > _______________________________________________
> > > Tesla mailing list
> > > Tesla@xxxxxxxxxxxxxx
> > > http://www.pupman.com/mailman/listinfo/tesla
> > >
> >
> > _______________________________________________
> > Tesla mailing list
> > Tesla@xxxxxxxxxxxxxx
> > http://www.pupman.com/mailman/listinfo/tesla
> >
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
> 

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla