[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [TCML] OBIT Questions



It's very easy to remove the tar from the older type oil burner transformers
by peeling off the metal case. The metal is thin and once you get a strip
started, you peel off the strip all around the case. Then you find that
there is not much tar inside, which takes only a short time to break off. Of
course, one must be very careful about not breaking off the HV leads. This
was my experience with two of these small transformers.

Godfrey Loudner   

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of jhowson4@xxxxxxxxxxx
Sent: Monday, November 03, 2008 6:39 AM
To: Tesla Coil Mailing List
Subject: Re: [TCML] OBIT Questions

Hey Kevin
" If you "cook" one and remove the core
from the tar and run it in oil, it will run a long time."
could you describe your method for getting these things out o the tar.  I
tried once and i ended up destroying a good transformer.
thanks
Jay. H
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla


_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla