[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TCML] RE: Could this be a breakout point?



It looks like the screw is largely "inside" the toroid and would likely be shielded by its proximity, so it would probably be OK.  Close though - don't move it any further away.

Is the screw head glued to the outside of the secondary form?  If it's on the inside and not well insulated, it could result in internal arcing.

Reagrds, Gary Lau
MA, USA

> -----Original Message-----
> From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
> Behalf Of Stephen J. Hobley
> Sent: Sunday, September 07, 2008 10:53 AM
> To: Tesla Coil Mailing List
> Subject: [TCML] Could this be a breakout point?
>
> I made some changes to the secondary today - creating a connection
> terminal for the toroid.
>
> http://www.stephenhobley.com/breakout.jpg
>
> But does this look like it might be creating an unwanted breakout point?
>
> Steve
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla