[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] X-ray cable best practices for feeder cable



 
 
In a message dated 1/6/09 12:20:23 P.M. Eastern Standard Time,  
rdj@xxxxxxxxxxxx writes:

>when  it comes to stripping
>cable I use a 2x4 with a hole drilled in it that  just clears the cable. I
>put a slit in the end of the 2x4 down to the  hole, then put a blade from a
>utility knife in the slit. Next use a "C"  clamp to hold the blade in
>position. Put the 2x4 in a vise , the roll  of cable is supported on a shaft
>allows me to pull the cable thru the  2x4 removing what is required. 

    Cool idea, Rich! Cheap, easy, simple, and it  works!
 
-Phil LaBudde

Center for the Advanced Study of Ballistic  Improbabilities
**************New year...new news.  Be the first to know what is making 
headlines. (http://www.aol.com/?ncid=emlcntaolcom00000026)
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla