[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Setting optimal phase angle of SRSG motor



Hi,

Sometimes you can tell somewhat by the sound.  When the two
firing points are somewhat balanced, the coil may sound more high-pitched.
If you have a scope, you can adjust the phase for two equal firing voltage
peaks in each 50Hz half-cycle.

Cheers,
John

 

 


 

 

-----Original Message-----
From: Teslalabor <teslalabor@xxxxxxxxxxx>
To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sent: Tue, Dec 7, 2010 1:04 pm
Subject: [TCML] Setting optimal phase angle of SRSG motor


Hi,

I actually try to find out the optimal phase angle position of the motor in 

my 200bps SRSG. I use a dummy load with halogen bulbs. I am not sure WHAT 

exactly the optimal point is! Is it, when the 4 firing-sparks at the 4 

electrodes seem to be of the equal "size" / brightness when variac is at 

full voltage or when the bulbs are of highest brightness (but this is not 

easy to see!) OR is it the point where all 4 electrodes begin firing at the 

same time when rising the voltage on the variac? But in this case, 2 of the 

4 electrodes seem to fire much brighter then the other 2, when variac at 

full voltage. So I am a little bit confused, which point I should take.



Stefan 



_______________________________________________

Tesla mailing list

Tesla@xxxxxxxxxx

http://www.pupman.com/mailman/listinfo/tesla




 
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla