[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] MOT sale



Jon, My face is red!..You're correct. 2 1/4 x 2 1/8 is right. The filament voltage was a typo. It/s 3.2 volts @ 13 amps. Sorry. Dan ----- Original Message ----- From: "Jon Danniken" <danniken@xxxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Tuesday, February 08, 2011 12:29 PM
Subject: Re: [TCML] MOT sale


Dan Casaregola wrote:
Have a large mot for sale.  Ideal for VTTC, or modification.  High
quality construction, no welds. See attached specs.  Asking $50 plus
shipping from California.  Photo available, contact off list please.

That sounds a lot like the MOTs from the old Sharp ovens, which look like this: http://img831.imageshack.us/img831/1037/sharpmot.jpg

The difference is that the one in the picture only has 3.2V for the filament (yours is 13.2V), and the core area is 2.25" x 2.125" (yours is 2.125" x 4.5").

Interesting that the rest of the specs are the same though; are you certain about the core area measurement (did you perhaps measure the shunts)?

Jon




_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla



_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla