Re: [TCML] Old TC restoration advice

[Futuret <futuret@xxxxxxx>]

correcting my post here;  I meant it's best not to run the ASRG at too
LOW a speed (again assuming it's a variable speed ASRG).  

Original transformer may have provided 60ma or more, which would
explain why performance suffered using the single 9kV NST.  If the
ASRG electrode spacing can be tightened up some (less distance
for the arc to jump) that may help too.   

John

 

 

 

-----Original Message-----
From: Futuret <futuret@xxxxxxx>
To: tesla <tesla@xxxxxxxxxx>
Sent: Sun, Oct 30, 2011 4:24 pm
Subject: Re: [TCML] Old TC restoration advice


Dave,



I think it may be worth trying the two 9kv NST's and Terry gap with

the coil.  The main reason for not using ASRG's is because of 

possible danger of damaging the NSTs but the Terry Filter takes

care of that, along with a safety gap.  Adding the extra NST may

smooth out the operation.  It may help too to boost the NST output voltage

using a step-up  (140V output) variac.  You shouldn't have to re-tune

the primary very much.  It's probably best not to run the ASRG at

too high of a speed if it's the variable speed type.  If it's not variable

speed then there's the issue of possible NST resonance with the capacitor

depending on the cap value.  If the safety gap has to be set too wide

that would be an indication of unwanted resonance.   



Cheers,

John



 





----- Original Message ----- 



From: "David Speck" <Dave@xxxxxxxxxxxxxxxx>



To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>



Sent: Sunday, October 30, 2011 8:25 AM



Subject: [TCML] Old TC restoration advice











> Esteemed list,



> 



> Halloween is rapidly approaching, and I find myself with no working TC 



> to demo to the Trick or Treaters.  Looks like the weather will be good 



> this year, so I can't use rain and snow as an excuse for not having a 



> working coil.



> 



> My best prospect for quick repair is a vintage coil that I bought from 



> the late Harry Goldman a few years (~15) back.  It has an ~4" x ~16 



> secondary, a 14" toroid, and a flat 12" pancake primary, and an 



> asynchronous RSG.  It ran beautifully until an overenthusiastic 



> assistant let it run a bit too long and burned out one of the unobtanium 



> transformers (open secondary).



> 



> It was driven by a series pair of exotic ex-military radar transformers, 



> supplying about 10 kVAC.  I'm not sure of the available current.  These 



> transformers were apparently self-ballasting, like a NST, and the coil 



> never used a separate ballast.



> I tried replacing the bad transformer with a 9 kV 30 mA NST, but the 



> coil runs very rough.  Not having a Terry filter in place, I didn't let 



> it run for more than a couple of seconds.  I have the parts for a Terry 



> filter, and have the assembly nearly complete.



> 



> A thought occurred to me, though, that somewhere I recalled that NSTs 



> generally don't work well with async RSGs.  Converting the ASRG to a 



> synchronous RSG on short notice is not likely doable.



> Any suggestions will be appreciated.




> Thanks,



> 



> Dave



> 



 
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla