[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TCML] 5.25" SRSG tesla coil suggestions on improving performance



Hi all,
I'm new here.  Although I've built a few coils in my past, I still consider myself a newb coiler.  I've never been the type to do things mathematically perfect, and tend to wing it as I go along, which may be my downfall here.  For the past couple of years on and off, I've been working on a 5.25" SRSG coil to use in a Halloween display.  This is my largest coil so far.  You can see it in action here:

http://www.youtube.com/watch?v=2P3T5zuT9DI


and pictures of the guts here:

http://imgur.com/a/0jgxR



I'd like to get some constructive criticism and advice on getting this running better.  This trips my 20amp breaker after about 10-15 seconds of running, so I figure about 2.2-2.6kw?  I'm currently getting 36" streamers, which I feel are somewhat weak.  They are purple, and not very bright.
Specs:

Large old powerstat variac salvaged from power equipment.  Not sure on exact specs, but I assume it should handle 30+amps with ease.  Wired for approx 150v boost.

Dual MOT's (pulled from 1200w commercial MWs), currently unballasted.  130uf of PFC caps behind them.
180nf MMC cap built with 10 strings of 8x 942c20p15k-f's.  1m bleed resistors installed.
SRSG is a 5" acrylic disc attached to a 1800rpm sync motor.  4 flying electrodes for 120bps.  Electrodes are 1/8" thoriated tungsten.  Phase is adjusted by twisting the motor in its mounts.
Primary is 3/8 copper tubing, slightly conical.  Currently tuned at about 2.25" turns
Secondary is 5.25" x 24" 22awg magnet wire with a couple of coats of poly.
Topload is a spun aluminum 4.5"x18" toroid.
All high current busses are 4awg stranded copper with large soldered lugs.

The next improvement I plan is to upgrade to 1/4" tungsten electrodes.  The stationary electrodes currently glow red hot after about 5 seconds of running, so I added a fan.
I'd love to get some bright long white snakes like I've seen from similar size coils.  Please advise!

Thanks!
JJ

P.S.  There is normally a safety gap installed, It just wasn't in place when I took those pictures.
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla