Hi Dave,
The disc is machined except for drilling holes for the four electrodes. I
forget the proper name for the material, but it is a cloth/resin board that
smells really bad when machined.
Thanks for your advice. I don't mind machining a larger diameter disc if
this would improve the performance.
I'll be back in the office on Monday.
Thanks again.
Tim
On Fri, Nov 1, 2013 at 4:40 PM, David Speck <Dave@xxxxxxxxxxxxxxxx> wrote:
> Tim,
>
> Perhaps a little small, but should work fine. 6 - 8" diameter might be
> more typical to give faster electrode movement (better cooling) and shorter
> dwell time.
>
> What will you fabricate your disc out of?
>
> Dave
>
>
>
> On 11/1/2013 3:00 PM, Tim Flood wrote:
>
>> For a SRSG, does anyone foresee any problems with disc diameter of 5.22"
>> and a rotating path diameter of 4.46" ? The disc will have four .25" dia.
>> electrodes running at 1800 rpm. HV supply will be a 15/60 NST.
>>
>> Thank you. AT least it's something to talk about.
>>
>> Tim Flood
>>
>
> ______________________________**_________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/**listinfo/tesla<http://www.pupman.com/mailman/listinfo/tesla>
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla