You can lay them out parallel and then mark an angled line across all of them with your desired spacing. That should then give you your spiral. Try it on scrap wood first.
perl -e 's==UBER?=+y[:-o]}(;->\n{q-yp-y+k}?print:??;-p#)'
t-burns14 <t-burns14@xxxxxxxxxxx> wrote:
I'm about to drill holes in my HDPE spokes and realized that if I drill all the holes in line, I'll end up with concentric circles and then a bent piece to get to the next circle level. Not good. So how do I do this properly in order to get an actual spiral?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla