[Home][2014 Index] Re: [TCML] Wanting to build a big coil [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Wanting to build a big coil



Looks like you really have it going on :)

My only concern in that list was the 30kv power supply. Is that an rms value? If so your going to have a lot of corona problems. 
Unless you already thought of that. 

Also what's your capacitance? 

John "Jay" Howson IV

Sent from a tiny phone with a tiny keyboard. 

----- Reply message -----
From: "mr. scot Dingman" <1stbunnykiller@xxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Subject: [TCML] Wanting to build a big coil
Date: Fri, Mar 28, 2014 6:03 am


Hey guys,

I want to build a really big coil, like as in bigbig.
Heres what I have
12"X56" secondary wrapped with 20ga.
3/8 Cu primary 17 turns
Polepig seriesed for 30KV output
Inductor set at 60A
Maxwell Caps seriesed for 250KV
Toroid 14"X60"
rotory gap with tungsten electrodes @ 1800rpm ( not 1760)
safety gap
Power Supply is
4 1256D series/paralelled for 280VAC at 100A

now to get this thing up and running....

BunnyKiller
aka Scot D
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla