[TCML] Coupling of oil insulated coils

[Barton B. Anderson]

I don't think those end caps will give you much of a problem. I would 
just leave them there and just use them for base and top connections for 
the secondary. I think a helical will probably do best on this coil with 
minimal interference with the bottom end cap. Will be interesting to see 
how it works out.

Take care,
Bart

J. Aaron Holmes wrote:
> I'm going to make several different ones, flat spiral,
> helical, and multi-layer flat spiral, and see which
> one performs best.  I'm just not sure how to design
> around those aluminum end caps.  The multi-layer
> option might be a good way to strike a balance between
> the increased coupling of a helical and the low
> vertical profile of a flat spiral, and that might
> prove important if it's discovered that proximity to
> the bottom end cap (being closer to it, that is)
> causes problems.  So we'll see!
>   
>