[TCML] Phase

[futuret at aol.com]

Tony,



The phase requirement changes with power level.? Therefore 

it can only be roughly set.? What I do is to just turn up the power

variac a little and adjust the phase using either my electrical

phase shifter circuit or a mechanical remote phase shifter,

and adjust for max spark length.? Then I raise the power some,

and re-adjust, etc, until full power and spark length is achieved.
If you have no remote adjuster, then make trial and error
adjustments and then power up again, etc.? 

? http://hometown.aol.com/futuret/page3.html

(please ignore any question marks that might show up above,
this email system sometimes creates them by itself.? )



John








-----Original Message-----
From: penny831 at earthlink.net
To: Tesla Coil Mailing List <tesla at pupman.com>
Sent: Wed, 28 Nov 2007 11:18 am
Subject: [TCML] Phase



Good morning all,
  I was wondering if anyone has any advise on presetting the phase on a SRSG? 
I'd like to set it right in the begining for maximum bang for my buck. I read 
about using a flurescent light but I could see anything when I tied that besides 
a spinning electrode. Your advise is appreciated.

Tony
_______________________________________________
Tesla mailing list
Tesla at www.pupman.com
http://www.pupman.com/mailman/listinfo/tesla


________________________________________________________________________
More new features than ever.  Check out the new AOL Mail ! - http://o.aolcdn.com/cdn.webmail.aol.com/mailtour/aol/en-us/text.htm?ncid=aolcmp00050000000003