[TCML] tery filter (terry filter)

[DC Cox]

Two reasons:

The resistors are large (25 or 50 watt) and since the center of the filter
is usually a ground strip, the edges must be at least 5 inches away to
prevent "HV creepage" across the insulating board.  Also, don't handle your
board with bare hands as it will deposit small amounts of sodium salts on
the board which could cause it to become slightly conductive and enhance
creepage (I use plastic gloves for good results).

Dr. Resonance




On Mon, Apr 28, 2008 at 2:05 PM, <Mddeming at aol.com> wrote:

>
> In a message dated 4/28/08 2:21:46 P.M. Eastern Daylight Time,
> eyemfedup2 at yahoo.com writes:
>
> hello
> I was wondering why all of the terry filters I've seen  are so big
> is there a reason or could it be made to be more  compact
>
>
> ---------------------------------
>
>
> Hi!
>
>  Welcome to the world of coiling. Please introduce yourself so we can
>  have a
> name to go by, get to know you, and can respond at the appropriate
>  technical
> level.
>
> Matt D.
>
>
>
> **************Need a new ride? Check out the largest site for U.S. used
> car
> listings at AOL Autos.
> (http://autos.aol.com/used?NCID=aolcmp00300000002851)
> _______________________________________________
> Tesla mailing list
> Tesla at www.pupman.com
> http://www.pupman.com/mailman/listinfo/tesla
>