[TCML] 6x24 spun toroid bulk buy, anyone?

[otmaskin5 at aol.com]

David, what do you figure the per unit cost would be at bulk rates?? Dennis Hopkinton MA


-----Original Message-----
From: David Rieben <drieben at comcast.net>
To: Tesla list <tesla at pupman.com>
Sent: Tue, 29 Jan 2008 1:02 pm
Subject: [TCML] 6x24 spun toroid bulk buy, anyone?



Hi all,

I am making gradual progress in my mid-sized SG driven coil
project and am beginning to think about a top load for it. Al-
though the dryer duct toroid is certainly the most economical
answer for a top load, it is not very asthetically pleasing and
is also too dent proned and fragile. I would like to get a 6x24
spun toroid and was hoping to get enough interest to pursue
a bulk buy  from O.W. Landergren to help somewhat reduce 
the cost. Any takers?

David Rieben
_______________________________________________
Tesla mailing list
Tesla at www.pupman.com
http://www.pupman.com/mailman/listinfo/tesla


________________________________________________________________________
More new features than ever.  Check out the new AOL Mail ! - http://webmail.aol.com