[TCML] Table Saw Blades for Phenolic LE

[Dave Leddon]

Hi Dan,

I've cut lots of this stuff using a blade designed to cut plastic:
http://www.amazon.com/Freud-LU94M010-10-Inch-Plexiglass-Plastic/dp/product-description/B00004T7AL
Cutting phenolic on a table saw generates a fine dust that covers 
everything in your shop and also releases some amount of formaldehyde 
which, as I understand it, should not be inhaled.  So I always wheel the 
saw outside and set up a large fan at my back to blow the dust away from me.

Dave

At 04:17 PM 2/10/2008, you wrote:
>Anyone have experience with cutting LE Phenolic on a table saw.  Looking
>for a blade recommendation for nice clean cuts.
>Just acquired a truckload of this stuff from a surplus auction and
>probably going to be building lots of stuff with it!
>
>Thanks
>
>Dan
>
>
>_______________________________________________
>Tesla mailing list
>Tesla at www.pupman.com
>http://www.pupman.com/mailman/listinfo/tesla