[TCML] rotary gap disk

[FIFTYGUY at aol.com]

In a message dated 11/29/08 3:31:24 P.M. Eastern Standard Time,  
plymouth_4406 at yahoo.com writes:

>If  the metal disc was mounted directly on the shaft and supported  on 
pillow block bearings and >driven with a belt you wouldn't need to  have an 
insulating hub. 

    The really slick thing to do would be to drive the  rotary with a Tesla 
Turbine! Air lines would provide the power source with  necessary insulation, 
throttling the air supply would change the BPS, and  exhaust air could be used 
to quench the gaps!
 
-Phil LaBudde

Center for the Advanced Study of Ballistic  Improbabilities
**************Life should be easier. So should your homepage. Try the NEW 
AOL.com. 
(http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000002)