[TCML] Could this be a breakout point?
Stephen J. Hobley
shobley at userfs.com
Mon Sep 8 06:27:11 MDT 2008
Sorry that wasn't clear - what I meant to say was "what I had before" - that was why I changed it to what was shown in the picture.
Based on the feedback, I changed it again, now there's just a single wire spiraling up to the contact point. I changed the main bolt to I can now remove the toroid without risking moving the coil wire.
317 201 4281
The Laser Harp Project - www.stephenhobley.com/build
From: tesla-bounces at pupman.com on behalf of bartb
Sent: Sun 9/7/2008 10:46 PM
To: Tesla Coil Mailing List
Subject: Re: [TCML] Could this be a breakout point?
Steve, what I described is not what you showed in your picture to the
TCML (it is not what you have now). You showed termination on the side
of the form (a bolt). I described termination from a top cap. Very
different as you don't have a top cap.
Stephen J. Hobley wrote:
> My goal has been to terminate the coil wire on the cylinder.
> The solution you describe is what I have now, and I'm concerned about
> the fragility of the coil wire.
Tesla mailing list
Tesla at www.pupman.com
More information about the Tesla