[TCML] Winding a secondary?
bunnikillr at cox.net
Fri Sep 19 19:47:26 MDT 2008
Do you have the time and finances to rewind? If not, then a splice is
in order. Try to cut the wire in a diagonal manner at the splice point,
solder the joint and insulate the joint with some hi quality insulator (
black or red Glyptol comes to mind ;) )... Ive done this type of
splice more times than I can remember and it holds up better than a
standard turn to turn insulative values...
Robert Davies wrote:
> What is an acceptable method of connecting a continuation of the wire
> for a secondary coil? example: I have a spool of 19ga magnet wire and
> say I get 70% of the winding complete and I run out of wire, well I
> have more of the same on another spool . I would rather buy enough
> wire for the entire wind but I would like to use what I have.
> Any Thoughts?
> Tesla mailing list
> Tesla at www.pupman.com
More information about the Tesla