[TCML] Terry Filter Resistors

[bartb]

Hi Ed, Gary,

WOW! I think your right. That sure puts a damper on my multi-layer 
technique! Would work in multilayer mode, but if a  1K 1/2W carbon is 
measuring 184mH, then yes, all bets are off and a good lesson learned 
with the 27XT (and maybe any LCR).

Excellent test Gary!
Take care,
Bart

Ed Phillips wrote:
> I also have a 27XT multimeter.  If I take a 1.0K Ohm, 1/2W carbon comp 
> resistor (i.e. NO significant inductance) and try to measure its 
> inductance with this meter, it reads 184mH.  I don't think so!
>
> Bottom line - don't try to measure inductance of resistors with this 
> meter!
>
> Regards, Gary Lau
> MA, USA"
>
>     Measuring any kind of coil with this type of meter is sort of a 
> gamble unless you know what you're doing - the measurement technique 
> is quite an indirect one.  Works OK with reasonable coil Q but not at 
> all suitable for measuring the inductance of a WW resistor.  To do 
> that I'd break one and try to figure out the number of turns and then 
> calculate it.  I don't think even a good impedance bridge would give 
> useful results.
>
> Ed