[TCML] Bi-Polar coil construction plans/tips/etc ?

[DC Cox]

Usually wound in opposing directions, base to end.

Be sure to use JAVATC to set coeff. of coupling to around 0.12.  This will
probably dictate the elevation of sec coil approx 2" above the primary
plane, but it also depends on your
pri to sec spacing.  Use JAVATC as if you are making a single vertical coil.

Dr. Resonance




On Tue, Mar 31, 2009 at 7:49 PM, david baehr <dfb25 at hotmail.com> wrote:

>
> was thinkin' of building one.... prob 6" dia  sec.   are output sparks
> generaly limited to the length of the sec. , or less ? ....is the sec. wound
> in the same direction from end to end ?,
>
>   would following plans from the 'High  Frequency Apparatus' book be of any
> use ??
>
>
>
>                          Thanks,dave :-)
>
> _________________________________________________________________
> Hotmail® is up to 70% faster. Now good news travels really fast.
>
> http://windowslive.com/online/hotmail?ocid=TXT_TAGLM_WL_HM_70faster_032009_______________________________________________
> Tesla mailing list
> Tesla at www.pupman.com
> http://www.pupman.com/mailman/listinfo/tesla
>