[TCML] method of routing secondary wire to toroid

[Craig]

Thanks everyone for your replies. I believe I am headed in the right
direction.

Craig

-----Original Message-----
From: tesla-bounces at pupman.com [mailto:tesla-bounces at pupman.com] On Behalf
Of Antonio Carlos M. de Queiroz
Sent: Saturday, April 17, 2010 8:24 AM
To: Tesla Coil Mailing List
Subject: Re: [TCML] method of routing secondary wire to toroid

Craig wrote:
> I searched the archives, but can't find the specific answer I'm looking
for.
> What is the best way to route the secondary wire from the last turn to the
> toroid? I've read where some space wind in free air up to the base of the
> toroid,
I made my secondaries with the wire ending at both sides soldered at 
rounded rectangles of brass foil
glued to the tube.
The assemblies at the lower and upper ends touch these tabs with metal 
foil springs. Nothing critical,
as the current there is not too high, and very solid and robust.

Antonio Carlos M. de Queiroz

_______________________________________________
Tesla mailing list
Tesla at pupman.com
http://www.pupman.com/mailman/listinfo/tesla