[TCML] MOT sale

[Dan Casaregola]

Jon,  My face is red!..You're correct.   2 1/4 x 2 1/8 is right.  The 
filament voltage was a typo.  It/s 3.2 volts @ 13 amps.  Sorry.  Dan
----- Original Message ----- 
From: "Jon Danniken" <danniken at comcast.net>
To: "Tesla Coil Mailing List" <tesla at pupman.com>
Sent: Tuesday, February 08, 2011 12:29 PM
Subject: Re: [TCML] MOT sale


> Dan Casaregola wrote:
>> Have a large mot for sale.  Ideal for VTTC, or modification.  High
>> quality construction, no welds. See attached specs.  Asking $50 plus
>> shipping from California.  Photo available, contact off list please.
>
> That sounds a lot like the MOTs from the old Sharp ovens, which look like 
> this: http://img831.imageshack.us/img831/1037/sharpmot.jpg
>
> The difference is that the one in the picture only has 3.2V for the 
> filament (yours is 13.2V), and the core area is 2.25" x 2.125" (yours is 
> 2.125" x 4.5").
>
> Interesting that the rest of the specs are the same though; are you 
> certain about the core area measurement (did you perhaps measure the 
> shunts)?
>
> Jon
>
>
>
>
> _______________________________________________
> Tesla mailing list
> Tesla at pupman.com
> http://www.pupman.com/mailman/listinfo/tesla
>