[Prev][Next][Index][Thread]

Motor speed control needed



I have a 220V 500W angle grinder that runs at 11000 RPM. I want to build
a speed control for it. Somewhere I heard I need to vary the voltage of the
fixed winding and keep using full voltage for the rotating ones.

Has anybody of you got more precise instructions or even a schematic diagram?

Why I didn't buy an angle grinder with speed control? Because it would have
costed over $100. This rubbish I have got (new) costed $20 and I think should
last enough if you think of its use as a RSG.



________________________________________________________________________

 Marco Denicolai                   Vista Communication Instruments, Inc.
 Hardware Development Manager      www.vistacom.fi   

 marco-at-vistacom.fi                 Kaisaniemenkatu 13 A
 fax:    +358-9-622-5610           SF-00100 HELSINKI
 phone:  +358-9-622-623-15         Finland

   Remember, Murphy was an optimist! I am not...
________________________________________________________________________