Re: Toroid Material

• To: tesla-at-pupman-dot-com
• Subject: Re: Toroid Material
• From: FutureT-at-aol-dot-com (by way of Terry Fritz <twf-at-verinet-dot-com>)
• Date: Fri, 23 Apr 1999 14:27:04 -0600
• Approved: twf-at-verinet-dot-com

In a message dated 99-04-23 06:26:35 EDT, you write:

<< Original Poster: "Andy Cleary" <gemware2-at-dreamscape-dot-com> 
 
 >	I was wondering if it is a good practice to use flexible aluminum duct
> plain as a torus without coating it with the shiny metal flue tape?  I had
> never seen it encouraged, but I found the flue tape to be too expensive for
> my budget.  I have noticed that most often the torus should be smooth, and
> if that be the case then I'm sure the plain duct would be right out.  Thank
> you for any comments,
 
> -Andy >>

Andy, 

There's no need to cover the ducting with tape.  My 12kV, 30ma NST
coil that gives 42" sparks just uses an uncovered ducting toroid.

John Freau

• Prev: Re: Question to european coilers
• Next: RE: Toroid Material
• Index(es):
  • Main
  • Thread