[Prev][Next][Index][Thread]

Re: Coil Winder (fwd)





---------- Forwarded message ----------
Date: Sun, 10 Oct 1999 11:20:25 -0700
From: Jim Lux <jimlux-at-jpl.nasa.gov>
To: Tesla List <tesla-at-pupman-dot-com>
Subject: Re: Coil Winder (fwd)

> 
> 
> ---------- Forwarded message ----------
> Date: Sat, 9 Oct 1999 11:48:24 -0500
> From: "Dr. Resonance" <Dr.Resonance-at-next-wave-dot-net>
> To: Tesla List <tesla-at-pupman-dot-com>
> Subject: Re: Coil Winder (fwd)
> 
> It's easy to make your own.  Buy a 15 RPM gear motor from a surplus house
> such as Nebraska Surplus or Fair Radio Sales (approx $25).
> 
> For endplates to couple to the motor use standard pipe flange mountings
> available from any plumbing shop or supply house.  Most of these have 4
bolt
> hole patterns. 

These are called "floor flanges" if you are looking through catalogs, or
want to act like you know what you are asking for at the counter (after
lots of sketching and describing, the guy goes, OH, you want a floor
flange!; Hey I'm a EE, not a plumber))


 Use 1/2 inch pipe (1/4 inch pipe for small coils up to 4
> inches dia) to form the vertical holder and some oversize scrap bearing
> blocks which attach to a pair of sawhorses.  These form your holder
system.
> They bolt up to a 3/4 inch circular piece of plywood which form the
winding
> endplates for your coilform.

You can also use a small square piece of plywood, with some blocks of 1x3
nailed on at the right radius, which is a whole lot easier than trying to
cut a nice circle out of plywood (unless you have a good band saw and jig,
for which cutting circles is easy).