RE: tweaking

["Christopher Boden" <chrisboden-at-hotmail-dot-com> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

>Original poster: "Richard Barton" <richardbarton-at-caving5.freeserve.co.uk>


I'm worried about the juice going the wrong way up the beam
>and blowing the laser.


Run the beam from the head through a pinhole in a piece of steel, copper 
sheet, or even Al tape, make sure it's well grounded. Make sure the Laser 
head is a VERY safe distance away, this should help a bit :)

Christopher A. Boden Geek#1
President / Founder
The Geek Group
www.geekgroup-dot-org
Because the Geek shall inherit the Earth!

________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail-dot-com