[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Fw: Polypropylene coil form



Luc-

See my "recipe" postings of 8/19 & 8/20 for how I made a secondary.  I
recommend 2-side "sticky-tape" for holding the wire in place prior to
varnishing it. I would think that would stick to polypropylene--at least
long enough & well enough to hold the wire.  If not, perhaps you could
rough-up the poly with sandpaper to give a "tooth" for the tape.

Ken Herrick

--------- Forwarded message ----------
From: "Tesla list" <tesla-at-pupman-dot-com>
To: tesla-at-pupman-dot-com
Date: Sun, 03 Sep 2000 16:59:05 -0600
Subject: Polypropylene coil form
Message-ID: <4.1.20000903165903.009f7f00-at-pop.dnvr.uswest-dot-net>

Original poster: "Luc" <ludev-at-videotron.ca> 

<snipped>

I have 2 nice piece of 4.5" polypropylene pipe, I want to make coils
with them . 

<snipped>

Do you have advice ?

Tx
Luc Benard




________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno-dot-com/get/tagj.