[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: On the fly tuning of a TC



Original poster: "Jason Petrou by way of Terry Fritz <twftesla-at-uswest-dot-net>" <jasonp-at-btinternet-dot-com>

good idea about the optical system, but the problem with the reciever part
of the system is how do I power it? I was thinking of it before but if you
hit a bettery with a streamer from a coil... keep in mind that I have only a
very limited amount of space (like 10cm) under the primary and the secondary
cannot be removed from the base - all batteries would have to go outside of
the assembly!

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Monday, April 16, 2001 6:12 PM
Subject: Re: On the fly tuning of a TC


> Original poster: "David Knaack by way of Terry Fritz
<twftesla-at-uswest-dot-net>" <dknaack-at-rdtech-dot-com>
>
> From: "Tesla list" <tesla-at-pupman-dot-com>
> > suddenly a streamer hit the primary [...] and the computer turned off.
It
> > turns out that I had fried the mainboard of the PC
> >
> > I have still not learnt from my mistakes, and am trying to develop an
new
> trpe
> > of on the fly tuning. Please reply wiht ideas (or just to take the
> p***!!!)
>
> Assuming you have a budget, I would recommend obtaining a length of
> fiber optic cable and build or buy a tranceiver assembly for it. Then
> you can build the motor and controller into a protected, possibly
> battery powered box under the coil.
>
> I personally would get rid of the computer and stepper motor and replace
> it with two cables, an H-bridge driver and a geared down servo.  You can
> run it forward or backward with a couple of switches and theres no risk
> to the computer.
>
> You could also try using shielded coil and a standard IC optocoupler,
> but I'm sure I wouldn't trust it to do any good at all against a
> direct strike to the cable.  I'd trust a homemade optocoupler much
> more.
>
> DK
>
>
>
>