[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Again with the forms? formless form ?



Original poster: "BunnyKiller by way of Terry Fritz <twftesla-at-uswest-dot-net>" <bigfoo39-at-telocity-dot-com>

Hi All...


was kicking around an idea that would be a formless form and possible to
make BUT...

it would be a coil that wont take much abuse as far as handling...

find a tube form of whatever diameter you wish,  cut it length wise in 2 spots
aproximately 1" apart ( 2 paralell cuts 1" apart along the length of the
tube) this
will produce a tube that can be somewhat colapsable when the 1" section is
removed.

tape the 1" section into its original place ( from the inside) and wrap the
tube
with some thing like waxed paper or such ( so the resin wont stick to it)

coat the waxed paper covered tube with some Behr50 ( maybe 2 coats) and let
dry,
then apply the wire and then recoat the wire with Behr50 again. Once
completely dry,
remove the tape and the 1" section of the tube. Twist the tube a tad to
"colapse" it
and slide the tube from the form.

the only problem that may occur is that the waxed paper or whatever used
may be a
bit stubborn to remove but if it does  WALA !!!

a secondary with only Behr50 as a supporting structure ( Behr 50 seems to
dry hard
and a bit brittle therefore the idea that it will be easy to break)

whatch think???   will it fly?

Scot D