[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Coil Frustration



Original poster: "Jason Petrou by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jasonp-at-btinternet-dot-com>

Hi there
Firstly I would check the caps. They look distinctly like microwave caps to
me and i dont think that they would be suitible for pulsed discharge. I
would next check the chokes, even remove them. It really is only NSTs that
need such devices - you should really be able to get away with it with an
ignition coil...

Jason
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Wednesday, June 27, 2001 4:16 AM
Subject: Coil Frustration


> Original poster: "CJ Moore by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<wizard1234-at-home-dot-com>
>
> I am somewhat of an amateur builder. I have made 2 coils. 1) was horribly
> pathetic and I won't even discuss it
> however, the second was in my opinion a decent small coil.
>
> Powersupply - 2x Ignition transformers 10 kv 23 ma (in parallel_
> Spark gap - series 4 bolts total gap of about .5 inches
> Capacitor - 2x .02 uf 1500 kv
> Primary - 7 turns of 3/4 inch copper refrigerator tubing (rising pancake
form)
> Secondary - 26 inches high 9 inch diameter wound with 22 gauge wire
> Toriod - Ventilation Duct (didn't work at all) just went with a copper
> terminal.
> 2 RF Chokes which were just pieces of pipe with about 200 turns of 22
gauge
> wire on them.
>
> With this system running, I would get a faint (really really faint) corona
> around the terminal, and if I put a grounded wire near it, maybe a 4 inch
arc.
>
> I have seen other coilers pages and pictures and some people have built
coils
> very similar to mine, but with much much better results, please tell me
what I
> am doing wrong!
>
> Here's a link to some pictures of my coil.
> I have made some modifications (but don't have pictures) This is my first
spark
> gap, not the one I use now. Don't think the transformers are hooked up
> correctly.
> Just for a general idea.
> <http://members.home-dot-net/fredmoore/>http://members.home-dot-net/fredmoore/
>
>
>