Re: coupling

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Kidd6488-at-aol-dot-com>

In a message dated 4/9/02 3:56:06 AM Eastern Daylight Time, tesla-at-pupman-dot-com
writes:


>
> > I think I have poor coupling.
> >
> > I have 1/4 inch copper tubing primary.  3/4" inside to inside spacing so
> > 1" center to center.
> > and 2" between innermost turn and primary.
> > What do some of yall run?



Hello everyone, I think my coupling is bad too,

6" sec.
.25" Cu Pipe .25" between turns
2" between the pri & sec coils.
My secondary is level with the primary coil, and it can only go up.

Is there anything else I can do to increase the coupling?
---------------------------------------
Jonathon Reinhart
hot-streamer-dot-com/jonathon