[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
my coil counterpois! oh ya!
Original poster: "J Dow by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jdowphotography-at-hotmail-dot-com>
Hello all
I was asking about using a large metal table (4�-20�) as a counterpoise.
The general consensus was that it would work. I ran the coil with the table
Friday and it was a major rock�n ark�n spark�n zap�n snap�n deal! My coil
put out some fine 5-foot streamers, very nice
Coil specs:
Power transformers:
2, 12kv/60ma NST�s banked for 120ma with PFC capacitor to smooth out the
current draw. On the HV side of the transformers is a serge filter good to
240ma 15kv to protect the transformers from over voltage (a Terry filter).
Control cabinet:
Two arming switches for mane coil power feed. A �dead-man� switch controls
power out to the coil through a 15 amp variac. The coil is fused to 15 amp
with a 15amp fast blow fuse.
My secondary:
It used to be this-
(10.5� cardboard concrete poring form, coil form.
36.5� winding 22awg
2, �� lexan disks inside the coil (inner arc prevention) at equal spacing.
Separating the inside of the coil onto 3 equal segments.
The coil was pre-coated with poly, inside and out and plenty after winding.
)
This burnt up. The coil form moved around on me causing shorted (overlapped)
turns.
I�ve made a new secondary. 4� pvc 1/8th wall thickness. 36� tall 35� winding
half inch space at both ends of the coil. 1750 turns 24 awg.
This coil is SO good; I don�t think I�ll ever make a 10� diameter coil
again. It does need a Big top load though. :(
Pri: Was a flat 20 turns � cu tube now it�s 12 turns 30-degree platter coil
for the smaller secondary. This also works like a charm.
Spark gap: SRSG 120BPS It consists of a small 1/25 hp 1800rpm motor that
spins a Plexiglas disk with 4 electrodes.
Capacitor:
16kv -at- 0.0692uf �MMC Geek cap�. This is an array of 36 Cornell Dubilier
capacitors. Each cap is rated for 2000V -at- .15uF there are 4 springs with 9
capacitors each.
Smaller is better!!!
Halloween is gona be so cool I don�t know what to do
Read you all later
Josh